Pour éditer le wiki, il faut demander un compte à un Lapin !
Difference between revisions of "LedFloor"
From Le L∞p's Wiki
(→Solution #4: added note about price --cw) |
(→Solution #4) |
||
Line 38: | Line 38: | ||
* 2* http://evilmadscience.com/tinykitlist/157 | * 2* http://evilmadscience.com/tinykitlist/157 | ||
− | * O(price) = 95*2 = $180 --or far less as you won't need the giant PCB. They have a "parts kit" that includes the 328 and the IC's for $15. you'd still need LED's and transistors and other support components. | + | * O(price) = 95*2 = $180 --or far less as you won't need the giant PCB. They have a "parts kit" that includes the 328 and the IC's for $15. you'd still need LED's and transistors and other support components. --cw |
+ | |||
+ | looking at the peggyLE schematics, they are not using several of the outputs, it looks like a 32x30 grid is possible with the IC's included, and by adding another IC in place of the buttons 32x45 is possible. --cw | ||
== Solution #5 == | == Solution #5 == |
Revision as of 18:50, 3 February 2011
Contents
Led Floor
How to turn the 11 windows of the hacklab into a big led display ?
- what have we got to do it ?
- Windows that are H189xW95.5 centimeters
- 1000 red leds
- loads of RJ45 and old IDE/SCSI/floppy buses
- what we need ?
- a system to control each diode (or group of diodes) independantly
- that is not too expensive
Solution #1
use a TLC5940NT that can control about 16 LED each
- datasheet: http://datasheet.octopart.com/TLC5940NT-Texas-Instruments-datasheet-153017.pdf
- schematic: http://webhome.csc.uvic.ca/~mcheng/samples/led_wheel/images/hack_schematic.jpg
- O(price) = $180 for the 64*TLC5940NT, so we'll need also several protoboard to be cut to bind them on.
Solution #2
use the snootlab's i2c led driver solution that can control 16 LED each
- 64*i2c led driver = 9.95*64 = 636.80
- 1*i2c shield = 17.95
- 1 ardunio = 20
- O(price) = 674.75 euros
Solution #3
- use shift registers... ?
Solution #4
use two Peggy 2 board :
- 2* http://evilmadscience.com/tinykitlist/157
- O(price) = 95*2 = $180 --or far less as you won't need the giant PCB. They have a "parts kit" that includes the 328 and the IC's for $15. you'd still need LED's and transistors and other support components. --cw
looking at the peggyLE schematics, they are not using several of the outputs, it looks like a 32x30 grid is possible with the IC's included, and by adding another IC in place of the buttons 32x45 is possible. --cw
Solution #5
- Check with Electrolab, where another similar project is ongoing :-)
Solution #6
- 42 ?