Pour éditer le wiki, il faut demander un compte à un Lapin !
Difference between revisions of "LedFloor"
From Le L∞p's Wiki
(→Led Floor) |
|||
| Line 41: | Line 41: | ||
== Solution #5 == | == Solution #5 == | ||
| + | |||
| + | * Check with Electrolab, where another similar project is ongoing :-) | ||
| + | |||
| + | == Solution #6 == | ||
* 42 ? | * 42 ? | ||
Revision as of 18:31, 3 February 2011
Contents
Led Floor
How to turn the 11 windows of the hacklab into a big led display ?
- what have we got to do it ?
- Windows that are H189xW95.5 centimeters
- 1000 red leds
- loads of RJ45 and old IDE/SCSI/floppy buses
- what we need ?
- a system to control each diode (or group of diodes) independantly
- that is not too expensive
Solution #1
use a TLC5940NT that can control about 16 LED each
- datasheet: http://datasheet.octopart.com/TLC5940NT-Texas-Instruments-datasheet-153017.pdf
- schematic: http://webhome.csc.uvic.ca/~mcheng/samples/led_wheel/images/hack_schematic.jpg
- O(price) = $180 for the 64*TLC5940NT, so we'll need also several protoboard to be cut to bind them on.
Solution #2
use the snootlab's i2c led driver solution that can control 16 LED each
- 64*i2c led driver = 9.95*64 = 636.80
- 1*i2c shield = 17.95
- 1 ardunio = 20
- O(price) = 674.75 euros
Solution #3
- use shift registers... ?
Solution #4
use two Peggy 2 board :
- 2* http://evilmadscience.com/tinykitlist/157
- O(price) = 95*2 = $180
Solution #5
- Check with Electrolab, where another similar project is ongoing :-)
Solution #6
- 42 ?
